~I
DLAN
D
____________
M_o_d_ei_M_X_T_1_0_5
INSTALLING
YOUR
RADIO
Preparation for
Installation
This radio may be
installed
in any 12-volt
negative ground system
vehicle
Most current
U.S.
and Foreign
vehicles
use a negative ground system,
but some
older models
and some newer
large
trucks may have a positive
ground. Check the specifications for your vehicle
before beginning
installation. Generally,
you have
a negative-ground system
if
the negative
(-) battery
terminal
is connected to the motor
block.
Contact your
dealer if
you are
unable
to determine your
vehicle's polarity
system.
1.
Read these instructions
completely before beginning
installation
2.
Read and
follow all
safety precautions in your
vehicle's Service Manual.
3.
Make sure all
necessary
tools, materials,
and parts are on hand.
4.
Disconnect the negative(-) battery cable
before installing
your
radio.
Be
sure to reconnect the
cable when
installation is
complete.
5.
Determine a mounting
location
for your radio. The MXT1
05
is designed
to be
installed
under the dash
or
vertically
on the center console. Choose
a
location
that does not impair visibility
or
interfere with driving.
Also
take
into consideration the routing and
length
of
the
lead
wires and cables
to
the power source, antenna, and/or
optional external speaker.
UNDER
DASH
MOUNT
CAUTION:
Extreme care should be exercised when drilling into
the dash to avoid damage to under dash electronic ignition,
cruise control, instrument and/or accessory wiring.
midlandusa.com
Page 5
To Next Page
Loading...
