Technical Information
6
B 890/B 990
2 Touch Current Measurement
Note:
Touch current measurement should be carried out on all accessible
conductive parts that are not connected to ground.
Warning!
Touch current measurement should only be carried out after the ground
connection of the appliance under test has been checked and found to be
satisfactory!
Dangerous voltages may exist on defective machines as well as on
accessible conductive parts that are not connected to ground!
Note:
No touch current measurement is necessary.
3 Risk of Injury Due to Tilting Mechanism
Warning!
When working on the appliance, the table and stand may tilt together/apart
unintentionally and this could cause injury.
The ironing table and stand are linked via a tilting mechanism. In its
transport (upright) position, the tilting mechanism is under tension; in its
working (horizontal) position, the tension in the table spring is released.
Before working on the appliance, tilt the ironing table into the working
(horizontal) setting and lock it in place.
When working under the ironing table, tilt the complete appliance
onto its back.
B Modification History
When Who What
3/8/2011 Jessica Naples Conversion for Website
11/10/2008 Liane Westerhelweg Version 4
8/19/2008 Liane Westerhelweg Version 3
11/20/2003 Olaf Meyer zu Drewer Version 2
6/29/1999 Jürgen Peller Version 1
To Next Page
Loading...
Need help?
General
