^
Turn upper connecting piece a and
pull it upwards to remove it. Remove
lower connecting piece b in the
same way.
^ Pull off dispensers c.
The Y-piece connector must not be
removed.
^ Clean all parts thoroughly.
^
Clean the surfaces around the central
spout (see arrow) with a well
wrung-out damp cloth.
^
Reassemble the dispensing unit in
the reverse order. Make sure that
upper connecting piece a clicks into
position. Press dispensers b firmly
into position.
Make sure that all parts are tightly
connected to one another.
^ Replace the dispensing unit in the
central spout.
^ Touch "OK".
^ Then refit the cover.
^
Touch "OK".
The central spout will now be rinsed
through.
Cleaning and care
59
To Next Page
Loading...
