Miele Built-in coffee machine User Manual

Maintenance of the milk valve
The milk valve should be cleaned once
a week to ensure good quality milk
froth.
^
Touch "Main menu" or the # sensor.
^
Touch "Maintenance" y.
^
Touch "Clean the central spout".
The central spout and the milk valve will
move into the maintenance position.
Important. You must remove the
cleaning brush before confirming
"Quit maintenance position" with
"OK". Otherwise the coffee machine
will be damaged.
^
Insert the brush in the milk valve and
move it back and forth.
^
Touch "OK".
The milk valve will move into the correct
position and the milk pipework will be
rinsed through.
Sensor cover
The sensor cover for the cup protection
cut-out is located under the central
spout. If the automatic spout
adjustment sensors do not clearly rec
-
ognise a container, this sensor will stop
the central spout.
If required, the sensor cover can be
cleaned by hand using hot water and a
little washing-up liquid.
^ To remove, press and hold the
sensor cover between the dispensers
a. Then press the central spout in
from the sides b.
This will release the sensor cover.
^
To replace, insert both hooks at the
back and press the sensor cover
upwards.
Cleaning and care
60

Miele Built-in coffee machine Specifications

General

Brand	Miele
Frequency	50-60 Hz
Programmable	Yes
Automatic Shut-off	Yes
Removable Drip Tray	Yes
Adjustable Coffee Strength	Yes
Adjustable Cup Height	Yes
Maintenance Indicator	Yes
Descaling Function	Yes
Rinse Function	Yes
Energy Saving Mode	Yes
Child Lock	Yes
Appliance category	Built-in
Voltage	220-240 volts
Material	Stainless steel
Color	Stainless steel
Milk Frother	Yes
Warranty	2 years