A faulty stainless steel hose must
only be replaced by a genuine Miele
replacement hose (available from
Miele). Make sure that the water
hose is suitable for food use.
Fitting the stainless steel hose
to the coffee machine
Make sure that the stainless steel
hose is not kinked or damaged. The
stainless steel hose must not be
shortened.
^ Remove the cover from the mains
water connection at the back of the
coffee machine.
^ Take the angled end of the stainless
steel hose and check whether there
is a washer. Fit one, if not.
^ Screw the coupling nut on the
stainless steel hose onto the
stopcock.
^
Ensure that all connections are
watertight.
Connection to the water inlet
Before making plumbing
connections, ensure that the
machine is disconnected from the
mains electrical supply.
Connection to the water supply should
be carried out by a qualified plumber
and should incorporate a stopcock with
a 3/4" thread.
^ Check whether there is a washer. Fit
one, if not.
^ Connect the stainless steel hose to
the stopcock.
Use the hose supplied with the
machine. Old or used hoses must
not be connected to the coffee
machine.
^
Ensure that it is screwed into position
correctly.
^
Turn on the stopcock slowly and
check for leaks. Correct the position
of the seal and union, if necessary.
Proceed with building in the coffee
machine (see "Installation").
Plumbed in water connection
88
To Next Page
Loading...
Need help?
General
