Safety instructions for installation
31
Fit the wall units and cooker hood before fitting the CombiSet to avoid dam-
aging it.
The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100°C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.
The CombiSet must not be installed over a fridge, fridge-freezer,
freezer, dishwasher, washing machine, washer-dryer or tumble dryer.
The electrical cable of the CombiSet must not come into contact
with any moving kitchen component (e.g. a drawer) or be subject to
any mechanical action which could damage it.
Observe carefully the safety clearances listed on the following
pages.
All dimensions are given in mm.
To Next Page
Loading...
Need help?
General
