Electrical connection
45
CS 1112 / CS 1122
All electrical work should be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations
(e.g. BS 7671 in the UK). Connection
should be made via a switched socket.
This will make it easier for service tech-
nicians should the appliance need to be
repaired. The electrical socket must be
easily accessible after installation.
CS 1134
This Combiset appliance must be con-
nected to the mains electrity supply by
a suitably qualified and competent per-
son, in strict accordance with current
national and local safety regulations
(e.g. BS 7671 in the U.K).
Danger of injury.
Miele cannot be held liable for unau-
thorised installation, maintenance
and repair work as this can be dan-
gerous to users.
Miele cannot be held liable for dam-
age or injury caused by incorrect in-
stallation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
If the plug is removed from the con-
nection cable or if the cable is sup-
plied without a plug, the appliance
must be connected to the electrical
supply by a suitably qualified electri-
cian.
If the switched socket is not access-
ible after installation, or if the appli-
ance is to be hard-wired, an addi-
tional means of disconnection must
be provided for all poles. When
switched off, there must be an all-
pole contact gap of at least 3mm in
the switch (including switch, fuses
and relays). Connection data is
shown on the data plate. It must
match the mains electrical supply.
After installation ensure that all elec-
trical components are shielded and
cannot be accessed by users.
To Next Page
Loading...
Need help?
General
