Technical Information
74
CVA 4062/CVA 4066/CVA 4068 Coffee Systems
2 Function
2.1 Water Tank
The CVA 4066 coffee system has a different water tank than the CVA 4062.
There are two magnetic floats in the water tank to monitor water levels (versus only
one float in the CVA 4062's water tank). An anti-splash tube is attached to the lid of the
water tank to prevent splashing of water while filling.
2.2 Filling the Water Tank
Bean and water quality are important for a good espresso or coffee. Therefore, the
water tank in a CVA 406x coffee system should be washed and filled with fresh cold
drinking water before each day of use (a reminder will be displayed when the machine
is turned on). In CVA 4066 systems, the water can be filled automatically with fresh
cold water. See Section 060-2.2.2.
Note:
Never add hot water or any other liquids except cold water to the water tank.
Do not use deionized or mineral water. Mineral water leads to heavy calcium
buildup in the machine that can cause damage.
2.2.1 Manually Filling the Water Tank
1. Open the appliance door by holding the grip next to the hot water spout and pulling
the door towards you. See Figure 060-1.
Figure 060-1: Pull Door Open
2. Pull the water tank out. See Figure 060-2.
Figure 060-2: Pull Water Tank Out
3. Fill the container with fresh, cold tap water to the "Max" mark. The valve on the
water tank ensures that water cannot leak out.
4. Close the lid and push the water tank into the machine until it clicks into place.
To Next Page
Loading...
Need help?
General
