Installation
*INSTALLATION*
85
Connecting the electricity supply
Observe the information under
“Electrical connection”.
Connect the coffee machine to the
electricity supply.
Pushing in and aligning the coffee
machine
Take care not to trap or damage the
electrical connection when pushing
the machine into the niche.
Push the coffee machine all the way
into the niche until you feel a
resistance.
Check the height of the coffee
machine to make sure that it is sitting
centrally in the niche and that it is
level. Align the appliance if
necessary.
Never align the coffee machine by
adjusting the door hinges. This will
prevent the milk container from
attaching correctly and interfere with
the milk preparation process.
Now screw the coffee machine to the
housing unit.
Open the appliance door.
Two TX20 (25mm) screws are
included with the machine.
Secure the coffee machine to the side
walls of the housing unit using the
screws supplied. Tighten both screws
by hand.
Useful tip: To make it easier to attach
the screw on the left, you can remove
the door opening limiters and increase
the door opening angle to approx.170°
(see “Door opening limiters”). Make
sure that there is sufficient space
available and that the appliance door is
not going to hit an adjacent wall.
Carry out a functional check on the
coffee machine.
Door opening limiters
The coffee machine door hinges are
equipped with door opening limiters
that restrict the opening angle of the
door to approx.120°. This will prevent
the door from hitting an adjacent wall
and being damaged when opened.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
