Cleaning and care
69
Clean the area around the central
spout with a damp cloth.
Reassembling the central spout
The dispensing unit is easier to
reassemble if the individual parts are
dampened with water beforehand.
Make sure that all parts are tightly
connected to one another.
Reassemble the dispensing unit.
Press down firmly so that the spouts
become securely connected to the
holder.
Insert the dispensing unit into the
coffee machine and connect the milk
pipework.
Refit the stainless steel cover.
Close the appliance door.
Fit cover to main dispenser appears in the
display.
Confirm the message withOK.
Cleaning the cup rim sensor
The cup rim sensor is located at the
bottom of the central spout.
Clean the cup rim sensor at least once
a week and more often if heavily soiled.
Press the two retainers together (see
arrows).
The cup rim sensor is released.
The cup rim sensor can be cleaned in
the dishwasher, or by hand using
warm water and a little dish
detergent.
To refit the cup rim sensor, press it
into the holder on the central spout
from below.
To Next Page
Loading...
Need help?
General
