Before using for the first time
23
Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Prerequisite:
– WiFi enabled Miele hob
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
See the Hob instruction manual for
details on how to connect them.
Instructions on how to connect the
cooker hood are repeated in detail
below.
Sign off the remote control (see
“Signing off the remote control”).
Switch the cooker hood off.
Press and hold the control.
Press the control at the same time.
2 will light up constantly, 3 will flash on
and off.
The cooker hood is ready for
connection in the next two minutes.
Start WiFi connection on the hob. For
further details, see the hob operating
instructions.
When successfully connected the 2 and
3 will light up constantly.
Quit connection mode on the cooker
hood by pressing the Run-on
control.
Con@ctivity has now been activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network.
Should this be required at a later date,
the WiFi connection between the hob
and the cooker hood must be
disconnected (see “Sign out of WiFi”).
To Next Page
Loading...
Need help?
General
