Miele DAS 8630 - Connecting Via WPS

Before using for the first time
19
 Touch the On/Off sensor.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control until the grease filter
and charcoal filtersymbols light
up.
 Touch the 2 control.
2 will light up constantly, 3 will flash on
and off.
The rangehood is ready for connection
during the next twominutes.
 Follow the instructions in the App.
When successfully connected 2 and 3
will light up constantly.
 Quit connection mode on the
rangehood by touching the run-on
control.
The rangehood can now be operated
via the App.
Connecting via WPS
Your Wi-Fi router must support WPS
(Wi-Fi Protected Setup).
 Touch the On/Off sensor.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control until the grease filter
and charcoal filtersymbols light
up.
 Touch the 2 control.
2 will light up constantly, 3 will flash on
and off.
The Wi-Fi connection must be started
on the rangehood at the same time as
on the Wi-Fi router.
 Press the B control on the rangehood
after a few seconds.
After a short while 2 will light up
constantly, and 3 and B will flash on
and off.
The rangehood is ready for connection
during the next two minutes.