Miele DAS 8630 - Altering or Deactivating the Charcoal Filter Operating Hours Counter; Deactivating Power Management

Changing settings
30
Altering or deactivating the
charcoal filter operating hours
counter
Charcoal filters are needed for
recirculation mode.
You can set the operating hours counter
to suit the type of cooking you do.
It has to be deactivated for extraction
mode.
It is set at the factory for 180hours of
use before the filters need replacing.
 Touch the On/Off sensor.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control until the grease filter
and charcoal filtersymbols light
up.
 Touch the charcoal filter symbol.
The charcoal filter symbol  and one of
the fan power levels will flash.
The fan power level indicators 1 to B
show the time set:
1............................................. 120 hours
2............................................. 180 hours
3............................................. 240 hours
B ......................................... deactivated
 Touch the relevant control to select
the duration required.
 Confirm your choice by touching the
charcoal filter sensor. If you do not
confirm your selection within
4minutes, the rangehood will
automatically revert to the previous
setting.
Deactivating Power
management
Keep in mind that deactivating this
function may increase energy
consumption.
Activating/deactivating Power
management
 Touch the On/Off sensor.
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control.
After a few seconds, the grease filter
and charcoal filter symbols light up,
and after a further 5seconds the 1 fan
power level indicator lights up.
The deflector plate extends.
 Then touch in turn
- the lighting control,
- the 1 control and then again
- the lighting control.
When Power management is activated,
the 1 and B indicators light up
constantly.
When it is deactivated, the 1 and B
indicators flash.
 To deactivate Power management,
touch 1.
The 1 and B indicators will flash.
 To activate, touchB.
The 1 and B indicators will light up
constantly.
 Confirm the setting by pressing the
run-on control.