Preparing the custom door
^
Open the appliance door.
^ Unscrew the installation supports n
from the appliance door.
^ Loosen the remaining screws from
the strips o on each side of the door,
then remove.
^ Set aside the screws and side strips
o - you will need them again later.
^ Remove the light switch cover (see
arrow).
^ Measure the distance X between the
bracket from the door and the
overhead furniture/fixtures.
^ Loosen the two nuts.
Set aside the nuts - you will need
them again later.
^ With the inside facing up, lay the
custom door on a stable surface (to
avoid scratch marks, place some
plastic or a cloth on the surface).
Installing the appliance
68
To Next Page
Loading...
