The dishwasher is programmed at the
factory for a water hardness level of
2.7 mmol/l (15 °d - German scale).
^
Select the water hardness you want,
and confirm your selection with
OK.
See "Programming the water
hardness level" for further
information.
These settings will be saved in memory
after the dishwasher has been through
one complete programme.
Finally, two messages will appear in the
display.
After confirming these,
Rinse aid low
and Insufficient salt may then appear
in the display to remind you to fill the
salt and rinse aid reservoirs. See
relevant sections on how to do this.
After you have confirmed these
messages with
OK, the display will
change to show the main menu.
Before using for the first time
25
To Next Page
Loading...
