Salt indicator
^
Fill the salt reservoir with dishwasher
salt for reactivation when the
F
Insufficient salt message
appears. (If it appears during a
programme, wait until the end of the
programme).
^
Confirm with
OK.
The "Insufficient salt" message will go
out.
After the salt reservoir has been filled,
the "Insufficient salt" message may still
appear in the display if the salt
concentration has not yet reached the
correct level.
If this is the case, confirm again with
OK.
The insufficient salt message will not
appear if the dishwasher has been
programmed for a water hardness level
of less than 0.7 mmol/l (4°d - German
scale).
,
After filling the salt reservoir, run
the
Quick wash programme immedi
-
ately (without any crockery in the
dishwasher, and without selecting
the Turbo function) to remove any
traces of salt water from the cabinet.
If you only ever use combination
products containing salt and rinse
aid in your dishwasher, you can
switch the messages off if you wish
(see "Settings menu - Refill display").
If you switch to using detergent that
does not contain salt or rinse aid, it
is important to remember to
replenish the salt and rinse aid and
to switch the messages back on.
Before using for the first time
30
To Next Page
Loading...
