Save extras
You can set additional functions, e.g.
Pre-wash, for individual programmes
(see "Operation, Select an extra
option(s)").
You can use the
Save extras option to
save settings you have chosen for a
particular programme so that they are
automatically selected when you run
the programme in the future.
The dishwasher is delivered with this
function deactivated.
^
Select the option you want and
confirm with
OK.
Temperature
The temperature can be displayed in
°C/Celsius or °F/Fahrenheit.
The factory default setting is °C.
^ Select the option you want and
confirm with
OK.
Buzzer
When the buzzer is activated, an
audible tone sounds at the end of a
programme and when there is a fault.
Buzzer at the end of a programme
You will hear the buzzer at the end of a
programme. It will sound four times in
bursts of three beeps with a noticeable
pause (approx. 15 seconds) in
between. Switching the dishwasher off
will switch the buzzer off.
The buzzer at the end of a programme
is deactivated as standard at the
factory.
Buzzer when there is a fault
In the event of a fault, the buzzer will
sound four times in bursts of three
beeps with only a very short pause in
between.
The buzzer which sounds if there is a
fault cannot be deactivated.
Setting the buzzer volume
The volume of the buzzer can be
selected in seventeen stages.
The buzzer cannot be deactivated in
the case of a fault.
^
Select the volume you want.
^
Confirm with
OK.
Settings menu !
89
To Next Page
Loading...
