Display brightness
The brightness is represented by a bar
with seven segments.
P P P P G G GM
Use the X arrow sensor to make the
display appear darker and the Y
sensor to make it brighter.
Buzzer tones
Melody
At the end of a process, a melody will
sound several times in intervals.
The volume of the melody is
represented by a bar with seven
segments.
P P P P G G GM
Use the X sensor to reduce the volume
or the Y sensor to increase it.
Maximum volume is selected when all
segments are filled.
If none of the segments are filled the
volume is switched off.
Solo tone
At the end of a process, a continuous
tone will sound for a period of time.
The pitch of this tone is represented by
a segment bar.
O O O O O O O O F F F F F FM
Use the X or Y sensor to alter the
pitch.
Keypad tone
The volume of the tone that sounds
each time you touch a sensor is
represented by a bar with seven
segments.
P P P P G G GM
Use the X sensor to make it quieter and
the Y sensor to make it louder.
Maximum volume is selected when all
segments are filled.
If none of the segments are filled the
keypad tone is switched off.
Settings
42
To Next Page
