Miele HS23 - Brush Cleaning and Roller Removal

Cleaning and care
29
 Press both release buttons at the side
of the fine dust filter lid and remove
the fine dust filter by pulling it up-
wards.
 Hold the fine dust filter over a bin.
 Take hold of the black section of the
fine dust filter underneath the screw
cap and turn the screw cap 10times
through 180°.
When turning the cap, you will hear a
noise, which is a normal part of how the
ComfortClean self-cleaning function
works.
 Empty the fine dust filter by carefully
tapping the lower edge.
 Turn the fine dust filter slightly while
you do this to free the dirt from all of
the crevices.
 Refit the cleaned fine dust filter into
the PowerUnit, making sure it clicks
into position.
To continue achieving the best pos-
sible cleaning results, replace the fine
dust filter (HX-FDF20) with a new one
after approx. 3years.
Cleaning the electrobrush/
handheld brush (depending on
the model)
 Disconnect the electrobrush/hand-
held brush from the vacuum cleaner.
 Place the electrobrush/handheld
brush upside down on a level, clean
surface.