Warning and Safety instructions
9
Temporary or permanent operation on an autonomous power sup-
ply system or a power supply system that is not synchronised with
the mains power supply (e.g. island networks, back-up systems) is
possible. A prerequisite for operation is that the power supply system
complies with the specifications of EN50160 or an equivalent stand-
ard.
The function and operation of the protective measures provided in
the domestic electrical installation and in this Miele product must
also be maintained in isolated operation or in operation that is not
synchronised with the mains power supply, or these measures must
be replaced by equivalent measures in the installation. As described,
for example, in the current version of BS OHSAS 18001–2 ISO
45001.
Charge the AP10/AP11 battery at an ambient temperature
between 10°C and 40°C.
Use the AP10/AP11 battery at an ambient temperature between
0°C and 45°C.
Using the AP10/AP11 battery outside of this ambient temperature
range will limit its performance.
Stop using the AP10/AP11 battery immediately if you notice an un-
usual smell from it, if liquid is leaking from it, if it is significantly over-
heating or if it is discoloured or deformed. Dispose of the AP10/AP11
battery immediately (see safety note “Disposing of the AP10/AP11
battery” at the end of the following section “Correct use”, as well as
“Sustainability and environmental protection – Disposing of old bat-
teries”).
Batteries will deplete over time. They can then leak corrosive flu-
ids. Avoid contact with the eyes and skin. In the event of contact,
rinse thoroughly with water and seek medical advice.
To Next Page
Loading...
