10841790-04
Installing the appliance
*INSTALLATION*
Securing the appliance in the
niche
1. Top mounting
2. Side mounting
Screw the appliance into position on
the right and the left.
Fitting a furniture door
If the appliance is being built into a run
of units, the height of the furniture
door should be aligned with adjacent
kitchen units.
The furniture door must be mounted
plane and free of tension.
The following chapter describes the
installation of a furniture door with a
furniture front of at least 16-19mm
thickness.
Ensure that the plinth panel is refitted
correctly.
A gap of 8mm is set at the factory
between the appliance door and the
fixing bracket. Double-check this gap
and adjust it if necessary.
Push the fitting aids up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see
in diagram).