Miele PDR 908 HP User Manual

Cleaning and care
61
Replacing the plinth filter
 Filter wear caused by continuous
tumble dryer use.
If the tumble dryer is in continuous
use and is being cleaned regularly,
the plinth filter can begin to show
signs of wear after a while. This can
clog up the heat exchanger.
Replace the filter immediately if you
see the following signs of wear be-
fore or after cleaning (optional ac-
cessory).
Poor fit
The edges of the filter do not sit prop-
erly and the filter is deformed. Fluff will
blow into the heat exchanger unfiltered
through edges that do not sit properly.
This will cause a permanent obstruction
in the heat exchanger.

Miele PDR 908 HP Specifications

General

Door hinge	Left
Drum volume	130 L
Control type	Touch
Loading type	Front-load
Product color	Stainless steel
Built-in display	Yes
Custom panel-ready	No
Appliance placement	Freestanding
Drying system	Heat pump
Drying capacity	8 kg
Delay start (max)	24 h
Residual moisture	48 %
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (drying)	- dB
Door opening angle	167 °
Current	10 A
Connected load	1440 W
Power plug type	Type F (CEE 7/4)
AC input voltage	220 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	777 mm
Width	605 mm
Height	850 mm
Weight	72000 g
Package depth	820 mm
Package width	660 mm
Package height	940 mm
Package weight	78000 g
Door opening diameter	370 mm