Miele PFD 101 U - Setting EcoStart; Setting SmartStart

Programme options
57
Setting EcoStart
You can use the EcoStartfunction to
benefit from cheaper electricity tariffs at
night. Before you can use this option,
you need to set up to three electricity
tariff time zones (see the “EcoStart”
section in the “Settings” chapter).
Then set the latest time by which the
selected programme has to be finished.
The dishwasher will then start
automatically in the most economical
tariff zone within the time set.
 Use the sensor controls to enter
the hour and confirm your entry by
touching OK.
The hour will be saved and the minute
number block will be highlighted.
 Use the sensor controls to enter
the minutes and confirm your entry
by touching OK.
The estimated start time for the
selected programme will appear in the
display for several minutes.
The selected programme will start
automatically when the estimated start
time is reached.
The time remaining will appear in the
display, the sensor control will go
out and the Startsensor control will
light up.
Setting SmartStart
The SmartStartfunction is used for
starting your dishwasher automatically
at a time when your energy costs are
most economical.
To use this function you may need
further technical accessories.
If you have activated the
SmartStartfunction in the Settings
menu, the Timermenu will no
longer show the EcoStartfunction but
will instead show SmartStart (see the
“Miele@home” section in the “Settings”
chapter).
If your energy provider offers this
service, they will send a signal to your
dishwasher when energy costs are at
their most economical.
This signal will start the dishwasher.
You can set the latest time by which the
selected programme has to be finished.
The dishwasher will then calculate the
latest possible start time for the
programme selected and will wait until
this start time for the signal from the
energy provider.