Miele PFD 101 U - Water inlet fault

Problem solving guide
76
Water inlet fault
Problem Cause and remedy
The warning buzzer is
sounding.
One of the following
messages appears in
the display:
 Open stopcock
The stopcock is closed.
 Open the stopcock fully.
 Water intake
Before rectifying the problem:
 Switch the dishwasher off.
The water inlet is restricted.
 Open the stopcock fully and start the programme
again.
 Clean the filter in the water inlet (see the “Cleaning
the filter in the water inlet” section in the “Cleaning
and care” chapter).
 The water-connection pressure is lower than
50kPa.
Seek professional advice.
 The on-site connection for the water drainage may
be too low and you will need to raise the water
drainage (see the “Hose installation” section in the
“Installation” chapter).
 Fault F18
A technical fault has occurred.
 Switch the dishwasher off.
 Close the stopcock.
 Call the Miele Customer Service Department.