Problem Possible cause Remedy
The "Water inlet" indica
-
tor light is flashing and
the programme does not
continue.
Before rectifying the pro
-
blem you must:
–
Press the "Start/Stop"
button for at least one
second.
–
Start the programme
again.
The stopcock is closed. Open the stopcock fully.
The water inlet filter is
blocked.
Before rectifying the pro
-
blem you must:
–
Press the "Start/Stop"
button for at least one
second.
– Switch the dishwasher
off using the "On/Off"
button.
Then:
– Clean the water inlet fil-
ter, see "Cleaning the
water inlet filter".
The water pressure at the
intake is lower than
0.3 bar.
Seek professional advice.
Problem solving guide
52
To Next Page
Loading...
