Use
16
Danger of burning on the hot edge of the heater plate.
When the machine has heated up, there is a danger of burns on the
edge of the heater plate. Warning labels on the outer casing of the
heater plate indicate the danger of burns.
Avoiding touching the edges of the heater plate.
Wait until the selected temperature has been reached.
The button begins to flash as soon as the minimum temperature
has been reached.
The flatwork ironer is ready for operation when the set temperature
is reached and the symbol no longer appears in the display.
Now press the flashing button to start up the ironer.
The ironer is now ready for use.
Ironing
Ironing temperat-
ure
The ironing temperature should be selected according to the type of
fabric being ironed.
Fabric Symbol Temperature Preset value
Nylon/artificial silk
100–110°C 110°C
Silks/woollens
111–150°C 125°C
Cottons/linens
151–185°C 180°C
Temperature selection buttons
The ironer temperature can be set either via the temperature selection
buttons (//) or alternatively via the or –buttons.
When adjusting the machine from a higher ironing temperature to a
lower ironing temperature, the heater plate must cool down first. In
this case, the heater element for the ironer is switched off. The red
symbol indicates that the current ironer temperature is still too high.
When the symbol goes out, this indicates that the selected tem-
perature has been reached.
Setting the iron-
ing temperature
Press the button on the control panel to access the ironing
temperature selection mode.
The button will then be highlighted with a bar underneath.
Now press one of the threetemperature selection buttons.
(For example, temperature selection button)
To Next Page
Loading...
Need help?
General
