Electrical connection
,
This installation should be
performed by an experienced and
qualified technician, in accordance
with local codes and regulations.
The washer comes with a power cord
and NEMA L6-30 plug.
The machine is supplied as standard
for connection to a 208/240 V, 60 Hz,
30 A, 2-phase electrical supply.
For extra safety it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
The machine must only be connected
to the voltage and frequency shown on
the data plate.
,
Do not install devices to
automatically turn the washer off,
i.e. a clock timer.
Installation
56
To Next Page
Loading...
