Fitting the standard floorhead a
^
Push the suction tube into the
floorhead and turn it clockwise or
anti-clockwise until it clicks into
position.
To remove the standard floorhead b
^
Press the release button (arrow) if
you want to separate the parts and
pull the handle out of the suction tube
with a slight twist.
Adjusting the floorhead c
The floorhead can be used for all
normal cleaning of carpets, rugs and
robust hard flooring.
It is important to observe the flooring
manufacturer’s cleaning and care
instructions.
Vacuum carpets and rugs with the
brush retracted:
^ Press the foot switch %.
Clean hard flooring which is not
susceptible to scratching with the brush
protruding:
^
Press the foot switch ).
Always clean hard flooring with
deep cracks or spacing between
floorboards with the brush
protruding.
Preparing for use
11
To Next Page
Loading...
