Miele SmartLine Series User Manual

Problem solving guide
41
Problem Cause and remedy
The SmartLine element
has switched off auto-
matically. When the ele-
ment is switched back
on,  appears above the
On/Off sensor con-
trol.
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
 Clean off any dirt and/or remove the object (see
“Safety features” – “Safety switch-off”).
After the SmartLine ele-
ment has been
switched on appears
in the timer display for a
short while. The Smart-
Line element does not
heat up.
The SmartLine element is in demonstration mode.
 Touch the0 and 2 sensor controls at the same
time until  flashes alternately with  in the
timer display.
The wok has switched
itself off automatically.
It has been operated for too long.
 Switch the wok back on again (see “Safety fea-
tures” – “Safety switch off”).
The overheating protection mechanism has been ac-
tivated.
 See “Safety features” – “Overheating protection”.
The Booster has deac-
tivated early automatic-
ally.
The overheating protection mechanism has been ac-
tivated.
 See “Safety features”.
The cooking zone is not
working in the usual
way on the power set-
ting selected.
The overheating protection mechanism has been ac-
tivated.
 See “Safety features”.
An operating noise can
be heard after the
SmartLine element has
been switched off.
The cooling fan runs until the SmartLine element has
cooled down and then switches off automatically.

Miele SmartLine Series Specifications

General

Brand	Miele
Model	SmartLine Series
Category	Hob
Language	English