Problem solving guide
43
Problem Cause and remedy
In the timer dis-
playflashes altern-
ately with numbers.
The overheating protection mechanism has been ac-
tivated.
See “Safety features – Overheating protection”.
, or
The fan is blocked or defective.
Make sure it has not been blocked by something
like a fork. Remove the cause of the blockage.
If this fault code continues to appear in the dis-
play, contact the Customer Service Department.
and other numbers
There is a fault in the electronic module.
Interrupt the power supply to the SmartLine ele-
ment for approx. 1minute.
If the problem persists after power has been re-
stored, please contact the Customer Service De-
partment.
To Next Page
Loading...
Need help?
General
