The dishwasher does not fill/drain.
Problem Possible cause Remedy
The buzzer sounds.
One of the following
messages appears in
the display:
Water inlet fault
Please open the
stopcock.
The tap is turned off. Turn on the tap fully.
Water inlet fault F12/F13
Before rectifying the problem,
you must:
–
Switch the dishwasher off
using the On/Off sensor K.
Water intake is
restricted.
– Turn on the tap fully and
start the programme again.
– Clean the water inlet filter
(see "Maintenance").
– The water pressure at the
intake is lower than 30 kPa
(0.3 bar).
Seek professional advice.
Problem solving guide
60
To Next Page
Loading...
