This tumble dryer has a multi-stage
filter system, consisting of the fluff
filters and additional fine filters in
the door and the door opening. There
is also a fine filter in front of the heat
exchanger for added protection.
Make sure you clean all the
filters at the correct intervals
The filters are located in the
following three positions:
1. in the door
2. in the door opening
3. in front of the heat exchanger unit.
,
The dryer must not be used
without the fluff filters or fine filters in
place or if the fluff filters/fine filters
are damaged in any way. This would
cause an excessive build-up of fluff
which in turn would cause a fault.
When to clean the surfaces of
the fluff filters
The surfaces of the fluff filters:
1. in the door,
2. in the door opening
should be cleaned after each
programme.
See "Cleaning the surfaces of the
fluff filters".
When to clean the additional
fine filters
The additional fine filters do not
need to be cleaned after each
drying programme. They should only
be cleaned with the prompt* to do
so appears in the display.
See "Cleaning the fine filters".
* When
Clean door filter appears:
1. Clean the fine filter in the door.
2. Clean the fine filters in the door
opening.
* When
Clean the plinth filter which is
located in front of the heat-exchanger
appears:
3. Clean the fine filter in front of the heat
exchanger unit.
^
To delete the prompt*: Confirm with
OK.
Cleaning and care
38
To Next Page
Loading...
Need help?
General