With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages in the display
Problem Possible cause Remedy
You are asked to enter a
code.
Access via a code has
been activated.
Enter the code (see
"Settings menu").
1
Adjust the load
The programme
is cancelled, the
buzzer sounds.
This is not a fault.
In some programmes, if
the drum has been
underloaded or is empty,
the programme will be
cancelled. This can also
happen if the items are
already dry.
Use the Warm air
programme in future for
drying individual items.
– open the door, add
extra items and then
close the door again.
N
Empty the
container
The programme
is cancelled, the
buzzer sounds.
The condensed water
container is full or there is
a kink in the drain hose.
– Empty out the
condensed water
container or check the
drain hose.
–
Switch the dryer off
and then on again.
:
Clean the door
filter
appears at the
end of a
programme.
This is a reminder to
clean the fine filters in the
door and the door
opening under running
water.
–
Clean the fine filters.
See "Cleaning and
care".
To delete the message:
–
Select OK.
:
Clean the plinth
filter which is
located in front of
the heat-exhanger
appears at the
end of a
programme.
This is a reminder to
clean the fine filter in front
of the heat exchanger
unit under running water.
Problem solving guide
45
To Next Page
Loading...
Need help?
General