Problem Possible cause Remedy
There are humming
noises.
The compressor is
operating.
These noises are quite
normal and do not indicate a
fault.
The display and the
sensors are not lit up
and the Start sensor is
flashing slowly.
The display and sensor
illumination switches off
to save energy.
–
Touch the Start sensor.
The display and sensors
will light up.
–
See "Settings, Display /
keypad illumination".
The programme does
not start.
No obvious cause.
–
Is the dryer switched on?
–
Is the plug correctly
inserted into the socket
and switched on?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
The display is in a
different language.
A different language
has been selected.
Set the language you want.
The flag symbol J will guide
you.
Power cut. A programme which was running previously will
continue automatically when power is restored to the
tumble dryer as long as the Cooling down phase had
not been reached.
The interior drum
lighting does not
come on.
The lighting switches
off automatically (to
save energy).
–
Switch the dryer off and
then on again.
–
If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.
Access via a code has
been activated.
–
When the code is entered
the lighting will come back
on.
Problem solving guide
49
To Next Page
Loading...
Need help?
General