Warning and Safety instructions
8
The tumble dryer must be isolated from the electricity supply in
the event of a fault and during cleaning and maintenance.
This tumble dryer must not be used in a non-stationary location
(e.g. on a ship).
Do not make any alterations to the tumble dryer, unless
authorised to do so by Miele.
Heat pump technology and refrigerant:
The heat pump in this tumble dryer uses a refrigerant which is
condensed by the compressor and led in a closed circuit through
the heat exchanger unit where heat exchange with the circulating
drying air takes place.
– The humming noises caused by the heat pump are normal and do
not impair the efficient functioning of the dryer.
– The refrigerant is not flammable or explosive.
– In general it is not necessary to leave the dryer standing for any
length of time before it is connected to the mains provided it has
been transported and installed correctly (see "Installation and
connection - Transporting the dryer"). However, if it has not been
transported as described, ensure that the recommended standing
time prior to first operation is observed. Otherwise the heat pump
can be damaged.
To Next Page
Loading...
Need help?
General
