Operation
This ceramic cooktop is equipped with electronic sensor
switches which react to finger contact.
To operate a cooking zone, touch the relevant sensor. Each
time you touch a sensor, an audible tone sounds.
The cooking zones have to be "active" when you want to set
or adjust a power setting or the duration.
To activate the cooking zone, touch the appropriate sensor of
the cooking zone. The sensor will start to flash on and off after
you touched it. While the sensor is flashing, set or adjust the
power setting or the duration.
Take care to keep the control area clean. Do not place
anything on the control area. The sensor switches may fail
to react or they could mistake the article or any dirt for a
fingertip contact, thereby activating a function or even
causing the cooktop to switch off automatically (see Safety
switch-off.)
Never place hot pans on the sensor switches. The
electronic unit underneath could get damaged.
Use
19
To Next Page
Loading...
