Programming
You can change the default settings of the programme
options (see chart). Several settings can be altered in
succession.
After calling up programming, P (programme), S (status) and
numbers appear in the cooking zone display. This shows the
current setting.
Calling up programming
^
While the cooktop is switched off, touch the sensor
switches s and $ at the same time until the appropriate
control light flashes.
Set a programme, set a status
^ Touch the front left cooktop sensor.
^ Touch the + or - sensors to set the required programme.
^ Touch the front right cooktop sensor.
^ Touch the + or - sensors to set the required status (see
chart).
How to store the settings
^
Touch the s sensor until the displays go out.
How to not store the settings
^
Touch the $ sensor until the displays go out.
Additional functions
34
To Next Page
Loading...
