Miele TX2070 - User Manual

100 pages

Save Page as PDF

To Next Page

Operating instructions

Washing machine

To avoid the risk of accidents or damage to the appliance, it is essential

to read these instructions before it is installed and used for the first time.

en-AU, NZ M.-Nr. 09 806 360

Main Page

Default Chapter1
- Operating Instructions1
- Washing Machine1
- Table of Contents2
Caring for the Environment6
Warning and Safety Instructions7
- Correct Use11
- Control Panel14
Operating the Washing Machine14
- Examples on How to Operate the Appliance16
Before Using for the First Time17
- Messages17
- Setting the Language17
- Running the First Programme18
Twindos19
- Inserting Cartridges/Containers20
  - Using Cartridges20
  - Using Containers21
- Opening the Settings Menu22
  - Settings for Ultraphase 1 and Ultraphase 222
  - Settings for Other Types of Detergent23
- Running the First Programme24
Washing Environmentally and Economically25
- Ecofeedback26
1 Preparing the Laundry27
2 Selecting a Programme28
3 Loading the Washing Machine29
4 Selecting Programme Settings30
5 Adding Detergent32
- Twindos32
- Detergent Dispenser Drawer33
- Capdosing34
6 Starting the Programme - the End of the Programme36
Spinning37
Delay Start39
- Selecting Delay Start39
- Changing a Programme and Settings39
- Cancelling Delay Start and Beginning the Programme Straight Away39
Programme Chart40
Extra Options45
- Short45
- Water Plus45
- Stains45
Garment Care Label Symbols47
Programme Sequence48
Changing the Programme Sequence50
- Cancelling a Programme50
- Interrupting a Programme50
- Changing a Programme and Settings50
- Adding or Removing Laundry after a Programme Has Started51
- Safety Lock52
Detergent53
- The Correct Detergent53
- Water Softeners53
- Detergent Dispensing Aids53
- Fabric Softeners and Liquid Starch53
- Miele Recommended Detergents54
Cleaning and Care58
- Cleaning the Drum (Hygiene Info)58
- External Casing and Fascia Panel58
- Cleaning the Detergent Dispenser Drawer58
- Cleaning the Twindos System60
  - Cleaning the Containers and Hoses60
- Cleaning the Water Inlet Filter61
Problem Solving Guide62
- The Programme Does Not Start62
- The Following Fault Message Appears in the Display and the Programme Has Been Cancelled63
- The Following Fault Message Appears in the Display at the End of a Programme64
- Problems with Twindos66
- General Problems with the Washing Machine67
- An Unsatisfactory Wash Result69
- The Door will Not Open70
- Opening the Door in the Event of a Blocked Drain Outlet And/Or Power Cut71
After Sales Service73
- Repairs73
- Optional Accessories73
- Warranty73
Installation and Connection74
- Front View74
- Rear View75
- Installation Surface76
- Transporting the Washing Machine to Its Installation Site76
- Removing the Transit Bars76
- Refitting the Transit Bars78
- Levelling the Machine79
- The Miele Water Protection System81
- Connection to the Water Supply82
- Drainage84
- Electrical Connection85
Consumption Data86
- Consumption Data for the Nominated Energy Labelling Programme According to AS/NZS 2040.1 & AS/NZS 2040.286
Technical Data88
Settings89
- Language90
- Detergent/Amount90
- Degree of Soiling90
- Buzzer Volume90
- Keypad Tone90
- Total Consumption90
- PIN Code91
- Temperature Unit91
- Display Brightness91
- Dark Display91
- Appliance Switch-Off Status92
- Memory92
- Water Intake92
- Pre-Wash Cottons93
- Soak Duration93
- Gentle Action93
- Reduce Temp93
- Water Plus94
- Water Plus Level94
- Maximum Rinse Level94
- Suds Cooling94
- Anti-Crease95
Optional Accessories96
- Detergent96
- Specialist Detergents96
- Fabric Care97
- Additives97

Other manuals for Miele TX2070

Operating And Installation Instructions56 pages

Questions and Answers

K
Kevin PetersonJul 28, 2025
What to do if my Miele Washer programme does not start?
- H
  hayesjeffreyJul 28, 2025
  If the Miele Washer programme doesn't start, there might be a few reasons. First, ensure the machine has power by checking if the mains plug is properly plugged in and switched on. Also, verify that the fuse or circuit breaker hasn't tripped. Another thing to check is whether the door is closed properly. If none of these are the cause, try switching the washer back on using the power button.