Settings
92
Appliance switch-off status
The washing machine will switch off
automatically after the end of the pro‐
gramme / Anti-crease phase or after
being switched on if no further selec‐
tion is made.
Options
– 15 minutes (Factory default setting)
The washing machine will switch it‐
self off after 15 minutes.
– 20 minutes
The washing machine will switch it‐
self off after 20 minutes.
– 30 minutes
The washing machine will switch it‐
self off after 30 minutes.
Memory
The washing machine will save the
settings (temperature, spin speed and
some of the options) which have been
selected for a programme after the
programme has started.
When this programme is chosen again,
these saved settings will appear in the
display.
Factory default setting: the Memory
function is switched off.
Water intake
You can choose between cold water
and hot water intake.
Options
– Cold water (default)
The washing machine will be operat‐
ed with cold mains only.
– Hot water
To save energy, hot water will be
used during the main wash if a tem‐
perature of 30°C or higher is selec‐
ted.
To be more energy efficient, you can
heat up your water with cheaper, en‐
ergy saving options, e.g. gas, solar
power, oil. The temperature has to be
below 60°C.
–
Hot water +
Hot water is used in the main wash
and during rinses. Rinsing with hot
water can reduce water consumption
by approx. 10%.
For technical reasons, the wash‐
ing machine must always be con‐
nected to cold mains water.
To Next Page
Loading...
