Overheating protection
Cooking zones
Each zone is equipped with overheating protection (internal
temperature limiter). This switches off the heating element
automatically before the ceramic surface overheats.
You can tell that the overheating protection has activated
because the heating switches on and off even when the
highest setting is selected.
Once the ceramic surface has cooled down to a safe level,
the heating will automatically switch back on again.
Overheating can be caused by:
–
a cooking zone being switched on without a pan on it
– heating up an empty pan
– the base of a pan not sitting evenly on the cooking zone
– the pan is not conducting heat properly.
Control panel
The electronics of the control panel are equipped with
overheating protection. This switches off the heating element
automatically before the ceramic surface overheats.
The fault message FE37 will be displayed.
Once the electronics have cooled off sufficiently, the fault
message will disappear and you will be able to operate the
cooktop normally.
The overheating protection can be switched on, if more than
one cooking zone is operated on a high setting for a longer
period of time.
Safety features
30
To Next Page
Loading...
