Miele TX2070 - Page 39

Problem Possible cause Remedy
The sensor
switches show
increased
sensitivity or fail
to react.
The sensitivity level of the
sensor switches has
changed.
Make sure that there is no
direct light (from the sun or
from an artificial source)
falling onto the cooktop. The
area surrounding the
cooktop, however, must not
be too dark.
Make sure the cooktop or the
sensor switches aren't
covered. Take any pans off
the cooktop and wipe away
any food deposits.
Interrupt the power supply to
the cooktop for approx. 1
minute.
If this does not solve the
problem, please call Miele.
F lights up in the
back left display,
E lights up in the
back right display
and the front
displays show
numbers.
left right
90There has been an alignment
fault after resetting the
appliance or after a power
cut. If the display doesn't
switch off after 5 minutes,
proceed as described on the
right.
91
92
93
37The overheating protection
mechanism has switched.
This doesn't indicate a fault.
You can continue operation
as soon as the fault message
has disappeared (see
"Overheating protection").
All other faults There has been a fault in the
electronics.
Interrupt the power supply to
the cooktop for approx. 1
minute.
If the problem persists after
reconnecting the appliance to
the power supply, please
contact Miele.
Problem solving guide
39