Installation
*INSTALLATION*
72
Removing the door seal and the
screws
Removing the door seal
Starting from one side and working all
the way round, pull the door seal up
to remove it.
Place the door seal on the lid of the
tumble dryer.
Removing the screws
You will need a Torx T20 screwdriver.
Use the Torx screwdriver to unscrew
the eight screws.
Place the eightscrews on the lid of
the tumble dryer.
Removing the outer plate from the
door
Holding the door firmly in one hand,
stand it upright on the blanket.
Take a firm hold of the door by the
lug at the top.
Place your other hand flat on the top
part of the outer plate, with your
thumb on the outside edge.
Use your flat hand and a little force to
turn and unfasten the outer plate.
The outer plate should disengage from
the door after a short turn.
Set the outer plate aside.
To Next Page
Loading...
