Miele TXD 160 WP - Page 74

Installation
*INSTALLATION*
74
Removing the caps
 Remove the screw from the cap
markedR and take off the cap.
 Set aside the screw you have
removed above the door.
 Install the cap markedR on the right-
hand side of the door.
 Remove the twoscrews from the cap
markedL.
 Pull the capL up to remove it and set
it aside above the door.
 Leave the twoscrews for the capL in
place on the left-hand side of the
door.
Converting the lock catch
 Push the lock catch all the way up
from the back of the tumble dryer.
 Remove the lock catch.
 Turn the lock catch 180° as shown in
the center of the image.
 Reinstall the lock catch on the
opposite side of the door.