Installation
*INSTALLATION*
76
Lower the door carefully without
twisting it. The door and the outer
plate must fit together like a pot with
its lid.
Place one hand flat underneath the
outer plate of the door.
With your other hand, take a firm hold
of the door by the lug.
Turn the door in the direction of the
arrow while pressing against the
outer plate slightly with your flat
hand.
The outer plate should engage in the
door after a short turn.
Inserting the screws and installing
the door seal
Use the Torx screwdriver to screw in
the eight screws.
The outer plate must be engaged in
the door correctly.
If it is not, it will not be possible to
screw the outer plate and the door
together, because the screw holes
will not line up with the screw
domes.
If the fit is not right, revisit and check
the “Installing the outer plate on the
door” step.
Push the door seal into the groove all
the way round.
To Next Page
Loading...
