Miele W 149 - Top-Up Rinse for Cottons

Top-up rinse for Cottons
At the end of the main wash addi
-
tional water flows into the drum and
the suds are cooled down.
Hot suds can damage plastic drainage
pipes.
Top-up rinse takes place when temper
-
atures of 95°C and 75°C are selected.
Top-up rinse should be activated:
–
to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– where the drainage pipes do not
comply with DIN 1986.
The washing machine is delivered with
the Top-up rinse for Cottons deacti-
vated.
Before the "Top-up rinse for Cottons"
programmable function can be se-
lected you must first select program-
ming mode.
Selecting programming mode
A The machine must be switched off
and the drum door closed. The
programme selector must point to
"Finish".
B Press the additional option buttons
"Short" and "Water plus" at the same
time and hold pressed in and:
C . . . switch the machine on with the
"I-ON/0-OFF" button.
D Let go of all these buttons.
The indicator light "Main wash" flashes
in the sequence display.
Selecting the programmable function
To select the "Top-up rinse for Cottons"
programmable function turn the
programme selector to -
Starch ***.
Activating
To activate "Top-up rinse for Cottons"
press the "START" button once.
The "Rinses" light comes on in the se
-
quence display.
Storing in memory
To store the "Top-up rinse for Cottons"
programmable function in the memory
SWITCH the machine OFF with the
"I-ON/0-OFF" button.
The "Top-up rinse for Cottons" program-
mable function is now stored in the ma-
chine’s memory.
Deactivating
If the "Top-up rinse for Cottons" pro-
grammable function is no longer re
-
quired it can be deactivated. To do so
repeat the procedure given above from
point A as far as the *** shown above.
Press the START button and the
"Rinses" indicator light will go out. The
function is now deactivated. Store in
memory by pressing the "I-ON/0-OFF"
button.
Programmable functions
39