Connection to the drainage
system
The machine drains via a drain pump
with a delivery head of 1 metre.
The drain hose is 1.5 m long. It must
not be kinked as this restricts drainage.
The swivel elbow at the end of the hose
can be turned in either direction, or can
be detached if required, with a sharp
twist and pull.
Drain hose connection:
^
Direct into a sink: Hook the hose over
the edge and secure. Make sure that
the water can flow freely to avoid
flooding and to prevent water from
being sucked back into the machine.
^
Connected securely to a floor gully.
^
Connected securely to a standpipe.
^
Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a non-return valve.
If required, the drain hose can be ex
-
tended to a length of 5 m. The neces-
sary parts can be purchased from the
Miele Spare Parts Department or your
Miele dealer.
Installation
56
To Next Page
Loading...
