Miele W 149 - Page 47

What to do, if . . . Cause . . . Remedy . . .
. . . the "Check inlet" indica
-
tor flashes during the
programme but the
programme is running nor
-
mally.
The water inlet is restricted.
–
The stopcock is not opened
far enough.
–
The inlet hose is kinked.
–
The water pressure is too low
–
The filter in the inlet hose is
dirty. Clean it.
. . . the "Check inlet" indica
-
tor flashes and the laundry
was not washed.
The water inlet is closed.
–
Open the stopcock.
–
Start the programme again.
. . . one of the following indi
-
cator lights is flashing
- "Soak/Pre-wash"
- "Main Wash"
- "Rinses"
- "Rinse hold"
There is a fault.
–
Press "I-ON/0-OFF" button to
release it.
–
Turn the programme selector
to "Finish".
–
Press "I-ON/0-OFF" button in.
–
Re-start the programme.
–
If the indicator light starts
flashing again, call the Ser-
vice Dept.
Problem solving guide
47