Multi-function display
D Display
E Display indicator lights
F This button has the following two
functions:
– Changes the display from
Load % , Detergent % and
Time left h/mins
– Sets the load sensors to zero
To enable you to wash environmentally
and economically:
– The washing machine calculates the
amount of laundry loaded. This is dis-
played as a % figure:
25/50/75/100%.
– the amount of detergent required is
then displayed as a % figure:
40/50/60/75/100%.
In other words dispense this % of the
total amount of detergent recom-
mended by the manufacturer for a
full load of laundry.
– the duration of the programme de-
pending on the programme and the
amount of the load (Time remaining
h/mins).
Please note that Load % depends
on the programme selected and ap-
plies to dry laundry only.
Important:
Loads of less than 25% will not regis-
ter in the display. However, the dis-
pensing recommendation will show
the minimum value of 40%.
Please note that in the following pro-
grammes the display will only show the
time remaining :
– Separate rinse
– Drain /spin
– Starch
The display will also show:
– delay start
– the programmable functions
(when in programming mode)
Description of the appliance
12
To Next Page
