Memory Function (P11)
If an additional option(s) is selected
for a programme, and / or the spin
speed is altered, the machine stores
these changes in memory at the start
of a programme.
When that particular programme is
chosen again, the display will show the
additional option(s) and / or spin speed
which have been stored for that pro-
gramme in the memory.
The washing machine is delivered with
the memory function de-activated.
Follow steps
1 to 7 to programme
and store in memory.
The programmable functions are acti-
vated to call up further features not
shown on the control panel by using
the additional option buttons in combi-
nation with the programme selector.
Before you begin, first ensure that:
– The washing machine is switched off.
– The drum door is closed.
– The programme selector is at Finish.
.
1 Press the additional option buttons
Short and Water plus at the same
time, hold pressed in and . .
2 . . . switch on the machine with the
I-ON / 0-OFF button.
3 Let go of all these buttons. P 0
appears in the display.
4 Turn the programme selector to Sep-
arate rinse:
5 The P will now flash in the display
alternating with the number 11
In addition, one of the following will
appear on the right of the display:
0 = Memory function is deactivated
1 = Memory function is activated
6 Press the START button to change
from one to the other. The display
will change accordingly from 0 to 1
or from 1 to 0 .
7 Switch the washing machine off with
the I-ON / 0-OFF button.
The setting you have selected is now
stored in memory and will remain so
until you alter it.
Programmable functions
37
To Next Page
Loading...
