Problem solving guide
With the help of the following notes minor faults in the performance of the ap-
pliance, some of which may result from incorrect operation, can be put right with-
out contacting the Service Department.
Repair work to electrical appliances should only be carried out by a suitably
qualified person in accordance with local and national safety regulations. Un-
authorised repairs could be dangerous.
The chart is divided into the following sections to help you:
– The programme does not start.
– The wash programme stops and a fault indicator light comes on.
– A fault indicator light comes on but the wash programme continues as normal.
– Problems with the load size indicator and the dispensing recommendation.
– General problems or an unsatisfactory wash result.
– The programme does not start.
Fault indicator Possible cause Remedy
The Anti-crease / Finish
indicator light is not on, or
the START indicator light
is not flashing.
There is no power.
Check that
– the mains plug is
plugged in.
– the fuse or circuit breaker
has not tripped.
The check light locked is
flashing.
The system lock
has been activated.
Deactivate the system lock.
The programme does not
start when Drain / Final
spin has been selected.
The washing
machine has not
been prepared for
using for the first
time.
Prepare the machine as
described in “Before using
for the first time”.
Problem solving guide
44
To Next Page
Loading...
